Pipe automation production line is a new type of pipe bending tool with the function of bending pipe and lifting pipe. It has many advantages such as reasonable structure, safe use, convenient operation, reasonable price, fast loading and unloading, easy to carry, multi-purpose of one machine, etc. It occupies a large share in the domestic hydraulic Pipe automation production line market, mainly used for installation and repair of pipes in factories, warehouses, docks, construction, railways, automobiles and so on. In addition to having the function of bending the pipe, it can also remove the bending parts and be used as a separate hydraulic jacking machine.

Then the Pipe automation production line purchased back should pay attention to the following points when using it:

1. Before operation, please check whether the lubrication points of the machine are short of oil, whether the safety protection device is reliable, whether the motion mechanism is loose, and so on.

2, start Pipe automation production line oil pump, check whether the system pressure is maintained within the specified range, if high, it will damage the hydraulic components, waste power, if too low, it will affect the work.

3, adjust the required position and Angle of the parts, and position the parts to the required length.

4, adjust the vertical lifting guide rail, so that the guide mold pressing cylinder forward can clamp tightly iron pipe.

5, so that the clamping cylinder can clamp the iron pipe.

6, the normal operation of the workpiece into the bending die, and the front end contact positioning, step down the foot switch, you can complete.

7. After the work, cut off the power supply and do a good job of cleaning and lubrication.

8, operation Pipe automation production line in case of emergency, should press the emergency stop button, and then turn the torque switch to the manual position, manual reset, if the fault occurs, please report in time.

Here we talk about eight ways to maintain Pipe automation production line:

1: When operating Pipe automation production line, it must be operated in strict accordance with the operation regulations (key points).

Two: Pipe automation production line must be kept clean, unpainted parts please apply anti-rust grease.

Three: Before starting each Pipe automation production line, add lubricating oil regularly, at a fixed point and quantitatively according to the requirements of the lubrication chart, and the oil should be clean without precipitation.

Four: Regularly check and repair the switch, safety, handle, to ensure its reliable work.

Five: The lubricating oil in the motor bearing should be replaced and filled regularly, and often check whether the motor part is working normally.

Six: Regularly check whether the triangle belt, handle, knob, button is damaged, serious wear should be replaced in time.

Seven: It is strictly prohibited for non-designated personnel to operate the equipment, and it must be stopped when people leave the plane.

Eight: Add oil, lubricate and clean Pipe automation production line 10 minutes before work every day.

According to the last station and experts, the Pipe automation production line, in addition to having the function of bending pipe, can also remove the cylinder in the bending pipe component as a separate hydraulic jacking machine. Generally, good anti-emulsification and anti-foam properties are used. Good lubricating oil.

Pipe automation production line https://www.john-sheng.com/Automatic-Production-Line